Rear Axle Bearing Remover Puller Set Extractor Service Repair Slide Hammer Kit

Description: Highlights Constructed From Heavy Duty Cast Steel Bearing puller makes it easy to remove semi-floating rear axle bearings Axle sizes this unit will work with 1" to 1-7/8", 1-5/16" to 2-3/8", or 1-3/8" to 2-7/8" Comes with storage case Slide hammer end thread is 5/8" TPI EASY STORAGE Heavy-duty plastic blow-molded carrying case for easy transportation, safe storage, and quick organization. EFFORTLESSLY REMOVE BEARINGS 8MILELAKE Rear Axle Bearing Puller to service semi-floating rear axle bearings on your vehicle; These tools make the job simple and prevent damage to your bearings when pulling; Much easier than claw-type axle bearing pullers that slip off and chew up the old bearings; For removal only, not intended for installation. EASY TO USE Slide flat end of puller through center of bearing and flat against backside of bearing, then slide washer down the center of the shaft against front side of bearing and tighten the nut on smaller end of puller, then thread a slide hammer (not included) to the puller and slide hammer back and forth until the bearing comes out; The washer captures the bearing firmly to distribute the applied force over the entire bearing and prevent damage. COMPATIBILITY This set works for most American domestic makes and models; Set includes the following sizes to fit main bearing tube – 1 inch to 1-7/8 inches, 1-5/16 inches to 2-3/8 inches, and 1-3/8 inches to 2-7/8 inches; Sizes permanently laser-etched on tool for easy identification; Each tool fits a basic slide hammer with a 5/8-inch x 18 thread pitch.

Price: 27.25 USD

Location: Azusa, California

End Time: 2024-10-29T05:38:43.000Z

Shipping Cost: 0 USD